Hanyang University, Korea Electrotechnology Research Institute, and KIST Develop Bilayer Combining Silver-Carbon and Carbon Nanofiber Layers
Capacity Retained at 92% After 250 Charge-Discharge Cycles...11.2 Percentage Points Higher Than Existing Structure

Expansion during charging and contraction during discharging are among the main causes of shortened service life in all-solid-state batteries, a next-generation battery technology. Korean researchers have developed a bilayer structure that evenly distributes lithium inside the battery and absorbs volume changes, helping to mitigate the problem of capacity degradation.


The National Research Foundation of Korea announced on November 17 that a joint research team led by Professor Lee Jongwon of Hanyang University, Principal Researcher Choi Jeonghee of the Korea Electrotechnology Research Institute, and Principal Researcher Jung Hoonki of the Korea Institute of Science and Technology (KIST) had developed a new bilayer structure that mitigates volume changes during the charging and discharging of anode-free all-solid-state batteries.

Fabrication process of a double-layer all-solid-state battery and its lithium storage mechanism. (a) Fabrication of the double-layer structure combining a silver-carbon layer and a carbon nanofiber layer. (b) Lithium stored inside the carbon nanofiber layer and between the two layers after charging. (c) Reduction in internal pressure fluctuations achieved by applying the double-layer structure. (d) How sequential lithium storage mitigates volume expansion and mechanical stress. Provided by the research team led by Professor Lee Jongwon of Hanyang University.

Fabrication process of a double-layer all-solid-state battery and its lithium storage mechanism. (a) Fabrication of the double-layer structure combining a silver-carbon layer and a carbon nanofiber layer. (b) Lithium stored inside the carbon nanofiber layer and between the two layers after charging. (c) Reduction in internal pressure fluctuations achieved by applying the double-layer structure. (d) How sequential lithium storage mitigates volume expansion and mechanical stress. Provided by the research team led by Professor Lee Jongwon of Hanyang University.

View original image

All-solid-state batteries are a next-generation battery technology that can reduce fire risks by replacing the liquid electrolyte in conventional lithium-ion batteries with a solid electrolyte. Anode-free all-solid-state batteries, in particular, can reduce weight and volume and increase energy density because they do not use a separate anode active material, such as graphite, during manufacturing. The technology has attracted attention for its potential to extend the driving range of electric vehicles, but volume changes during charging and discharging have been considered a barrier to commercialization.


During charging, lithium ions that have moved from the cathode gain electrons and accumulate as metallic lithium, increasing the battery's internal volume. During discharging, the accumulated lithium turns back into ions and moves, reducing the volume. Repetition of this process can destabilize contact between the electrode and solid electrolyte and cause mechanical damage inside the battery, potentially shortening its service life.


To address this issue, the team designed a bilayer structure combining a thin silver-carbon layer with a carbon nanofiber layer containing abundant internal voids. The silver-carbon layer guides lithium to accumulate evenly rather than concentrating in specific areas during the initial stage of charging. As more lithium flows in, the carbon nanofiber layer stores it in its internal voids, mitigating volume expansion.


By tracking lithium migration and accumulation through structural analysis and computer simulations, the team found that lithium first accumulates in the silver-carbon layer during the initial stage of charging, then fills the voids in the carbon nanofiber layer, and subsequently accumulates between the two layers.


Capacity Maintained at 92% After 250 Charge-Discharge Cycles


When the bilayer structure was applied to an actual pouch cell, the cell retained 92.0% of its initial capacity after 250 charge-discharge cycles, even at the relatively low pressure of 2 megapascals (MPa). This was 11.2 percentage points higher than the capacity retention rate of a cell using only the existing silver-carbon layer (80.8%). The results demonstrated the potential to improve battery service life by mitigating mechanical damage caused by charging and discharging.

The joint research team that developed a bilayer structure for all-solid-state batteries. From left: Professor Lee Jongwon of Hanyang University; Principal Researcher Choi Jeonghee of the Korea Electrotechnology Research Institute; Principal Researcher Jung Hoonki of the Korea Institute of Science and Technology; and co-first authors Kang Junhee and Lee Taeyoung. Photo courtesy of the National Research Foundation of Korea.

The joint research team that developed a bilayer structure for all-solid-state batteries. From left: Professor Lee Jongwon of Hanyang University; Principal Researcher Choi Jeonghee of the Korea Electrotechnology Research Institute; Principal Researcher Jung Hoonki of the Korea Institute of Science and Technology; and co-first authors Kang Junhee and Lee Taeyoung. Photo courtesy of the National Research Foundation of Korea.

View original image

However, these results were verified under experimental conditions. Before the technology can be applied to actual electric vehicle batteries, stable performance must be achieved in large-area, stacked cells, and long-term charge-discharge durability must be further validated.


“This study is significant because it presents a new approach that goes beyond existing technologies for promoting uniform lithium deposition and can also mitigate mechanical damage during charging and discharging,” Professor Lee said. “We plan to develop the technology to deliver stable performance in large-area, stacked all-solid-state batteries and enable long-term operation at room temperature and under low-pressure conditions.”



The study was conducted with support from the Ministry of Science and ICT and the National Research Foundation of Korea. The findings were published online on November 5 in the international journal Advanced Energy Materials.


This content was produced with the assistance of AI translation services.

© The Asia Business Daily. All rights reserved. Unauthorized AI training and use prohibited.