Professor Ju Hyun Song’s Team Implements Central Cooling Channel in Battery Cells
Reduced Charging Time and Lower Production Costs

The research team at Korea Institute of Energy Technology (KENTECH) has developed a next-generation cylindrical battery that dramatically improves the heat generation problem that has long hindered fast charging of electric vehicle batteries. By utilizing a new structure with a cooling channel at the center of the battery, this breakthrough simultaneously enhances charging speed, lifespan, and cost efficiency, drawing attention as a new alternative in the next-generation electric vehicle battery market.


KENTECH announced on July 30 that Professor Ju Hyun Song’s research team in the Department of Energy Engineering has developed a ‘Tubular Form Factor Battery’ featuring a channel through which coolant flows at the very center of the cell.

Juhyun Song, Professor at Korea University of Energy and Science and Technology.

Juhyun Song, Professor at Korea University of Energy and Science and Technology.

View original image

Recently, electric vehicle batteries are trending toward larger cells to improve energy density and reduce manufacturing costs. In particular, cylindrical batteries are rapidly increasing in size from 18650 to 2170 and 4680 formats; however, as the diameter of the cells increases, structural limitations have made it more difficult for heat generated inside the cell to dissipate outward.


Consequently, the internal temperature rises rapidly during fast charging, which results in performance degradation and safety issues, thereby restricting the potential to increase charging speeds.


The research team reduced the distance that heat needs to travel by half by introducing a cooling channel in the center space that had previously been unused in cylindrical batteries. This new cooling structure allows heat to be dissipated simultaneously from both the interior and exterior of the cell.


The improvement in performance was also significant.


Under 6C fast-charging conditions with a 46mm large cell, the maximum temperature of a conventional battery rose to 58.1°C, whereas the tubular battery maintained a temperature of just 44.5°C, representing a 13.6°C reduction. In addition, the time required to charge the battery from 5% to 95% was shortened from 12.4 minutes with conventional batteries to just 9.6 minutes.

Comparison of Thermal Behavior Between 4680 Cylindrical Cell and Prismatic Cell Under C-Rate Fast Charging Conditions<br>A: Comparison of maximum and average temperature changes over time. B, C: Comparison of cross-sectional temperature distribution at the time of maximum temperature (B: cylindrical cell, C: prismatic cell). Provided by Korea Energy Engineering University

Comparison of Thermal Behavior Between 4680 Cylindrical Cell and Prismatic Cell Under C-Rate Fast Charging Conditions
A: Comparison of maximum and average temperature changes over time. B, C: Comparison of cross-sectional temperature distribution at the time of maximum temperature (B: cylindrical cell, C: prismatic cell). Provided by Korea Energy Engineering University

View original image

Battery lifespan was also dramatically increased. In a 500-cycle fast charge–discharge durability evaluation, the capacity retention rate of conventional cylindrical batteries was 76%, while the tubular battery maintained 91.5%, indicating a 15.5 percentage point improvement in durability.


Cost-effectiveness was also achieved. The research team analyzed that the improved cooling performance enables even larger cell sizes, which can reduce manufacturing costs by approximately USD 2.9 per kWh for 10-minute fast charging.


Most of the existing cylindrical battery production processes and battery pack assembly facilities can be used as they are, raising expectations for commercial viability.


Professor Ju Hyun Song commented, “This research proposes a completely new form factor for cylindrical batteries, which have seen little change over the past 30 years, and fundamentally resolves the physical heat generation limitations of large cylindrical batteries. We anticipate this will serve as a significant turning point as cylindrical batteries evolve into an era of even larger cells.”



This research was published in the international academic journal ‘Device’ by Cell Press and was supported by the Ministry of Science and ICT, the National Research Foundation of Korea, and the Korea Evaluation Institute of Industrial Technology (KEIT).


This content was produced with the assistance of AI translation services.

© The Asia Business Daily. All rights reserved. Unauthorized AI training and use prohibited.

Today’s Briefing